Side X side with a standard 1/2" hose barb:
![Image](http://www.brewershardware.com//images/TFB58_SideXSide.jpg)
Comparison of bore diamters:
![Image](http://www.brewershardware.com//images/TFB58_BoreComp.jpg)
1/2" full bore hose barb
Moderator: Post Moderators
BrewMasterBrad wrote:I hate you Derrin. I hate you and your stainless steel beer porn. Damn you.
Now I am trying to count how many of these I have on my system and figuring out how much it's going to cost to replace them.
How about a female thread X barb one? That way I can leverage the existing QDs on my system like this one:
Mated to something like this:
MoreBeer sells the QDs with barb fittings rather than threaded, but I think the ID closer to 3/8.
Well Brad, you're wish is my command.... The female version should be here in about 3 weeks +/-BrewMasterBrad wrote:How about a female thread X barb one?
It's all good until customs decides you don't really need those until Valentine's day (or was that St. Patrick's day).backyard brewer wrote:Well Brad, you're wish is my command.... The female version should be here in about 3 weeks +/-BrewMasterBrad wrote:How about a female thread X barb one?
Veeeeerrrry funny.jward wrote:It's all good until customs decides you don't really need those until Valentine's day (or was that St. Patrick's day).backyard brewer wrote:Well Brad, you're wish is my command.... The female version should be here in about 3 weeks +/-BrewMasterBrad wrote:How about a female thread X barb one?