It's 2 Tri-Clover ferrules welded together and then the thermowell tube is welded in place.
Tri-Clover In Line Thermowell
Moderator: Post Moderators
-
backyard brewer
- Posts: 3774
- Joined: Fri Feb 18, 2005 5:38 pm
- Location: Orange County, CA
- Contact:
Tri-Clover In Line Thermowell
I know there aren't a lot of people using Tri Clover fittings on this forum, but here's the latest addition to the Brewer's Hardware lineup:
It's 2 Tri-Clover ferrules welded together and then the thermowell tube is welded in place.
It's 2 Tri-Clover ferrules welded together and then the thermowell tube is welded in place.
Become a Brewer's Hardware Fan on Facebook!-
maltbarley
- Posts: 2413
- Joined: Thu Dec 08, 2005 9:31 am
- Location: Orange, CA
Re: Tri-Clover In Line Thermowell
What size Tri-clamps are you making? I like that little gizmo but all my stuff is 1/2"OD,
3/8"ID, 1" ferrule diameter. I can think of a couple other things that would be cool additions to the brewmagic.
3/8"ID, 1" ferrule diameter. I can think of a couple other things that would be cool additions to the brewmagic.
-
backyard brewer
- Posts: 3774
- Joined: Fri Feb 18, 2005 5:38 pm
- Location: Orange County, CA
- Contact:
Re: Tri-Clover In Line Thermowell
Everything I'm doing right now is 1 or 1.5" tubing size, almost 2" flange size. I can work with the smaller stuff, but I don't have a good line on sourcing the smaller fittings. Both 1" & 1.5" use the same clamp.