I'm selling a Stand built mostly to Brutus 10 dimensions. The bottom horizontal supports are lower to give more space for the heat and it's about 2" taller overall. The top corners are mitered instead of capped. All top surface welds are ground flush to avoid snagging your kettles. I still have to weld on the caster plates, bolt on the casters, weld in the two center supports and finish cleaning the welds. The stand is 304 stainless steel.
This was used to fabricate a fixture and test a couple different weld positions and techniques so I'm selling it basically for cost. This one does not have a gas beam or gas system for that matter.
That looks sweet Derrin. If I had any money at all right now, I would buy it. I could just transfer all the gas and electric from my mild steel Brutus stand to the stainless one. Nice work. Maybe when I get a job I will have you weld one for me.
I saw a werewolf drinking a pina colada down at Trader Vic's
Become a Brewer's Hardware Fan on Facebook!