excess foaming
Moderator: Post Moderators
excess foaming
just had my perker simi-explode after brewing a big porter. so much foam blocked the top perker till the pressure built and the whole top blew off! think I was able to save the beer - took some out and tasted OK. but any suggestions to not have this happen again would be nice
-
JonW
- Site Admin
- Posts: 1163
- Joined: Sat Jan 23, 2010 12:21 am
- Location: Huntington Beach, CA
- Contact:
Re: excess foaming
Um, I have to ask... what is a perker?
Re: excess foaming
Did you have to mop the ceiling? 
The answer is a blowoff tube...
Here's one on a bucket: http://surrealstudio.net/Beer/blowoff1.jpg
And one on a carboy: http://stlhops.com/wp-content/uploads/2 ... 0x1200.jpg
Essentially you need some way for the krausen to exit without building up pressure. So rather than a little tiny airlock you create a really big airlock. With the end of the tube put into sanitizing solution, you've got a system where CO2 can get out, but air can't get in.
The answer is a blowoff tube...
Here's one on a bucket: http://surrealstudio.net/Beer/blowoff1.jpg
And one on a carboy: http://stlhops.com/wp-content/uploads/2 ... 0x1200.jpg
Essentially you need some way for the krausen to exit without building up pressure. So rather than a little tiny airlock you create a really big airlock. With the end of the tube put into sanitizing solution, you've got a system where CO2 can get out, but air can't get in.
Brad